Cutting drainage holes in stages is good for plants and saves water

A good start to a crop grown in substrate will ensure good plant and root development. In this context it’s worth paying extra attention to the cutting of the drainage holes, says Grodan’s technical specialist. “We advise growers to cut the holes in our slabs in two stages, to promote healthy root development in the slab, more uniform growth in the control phase and a substantial reduction in the amount of water that needs to be recycled or purified.”

20190110 GR PHO 301
1/1

There’s been a change in the height of the stone wool slabs that growers use for their crops. Whereas they tended to use slabs with a height of 7.5 cm in the past, many now opt for 10-cm-high slabs. This trend became especially apparent after the introduction of the Next Generation 2.0 technology, says Grodan specialist. Now, high crop-specific slabs are available for all crops.

The top layer of today’s slabs remains moister, and forms a good connection with the propagation block. But this, combined with the slab’s greater height, may imply greater suction of the slab on the block. This effect of the slab extracting moisture from the block is the reason why drip irrigation has to be switched on several times per 24 hours from the time of planting until the young plant’s roots have penetrated the slab. “We have found that it’s better to drain the slab in two phases rather than one after its saturation,” explains Goes.

Main lines of the approach

  • Saturate the slabs for at least 24 hours using water with a sufficiently high EC.
  • Cut a hole above the seal to allow 1/3 pre-drainage of the slab; place the block on the plant hole.
  • Switch on your drip irrigation once or at most twice a day for the first few days.
  • Switch off the irrigation as soon as the first roots have penetrated the slab by about 2 cm.
  • Cut the definitive drainage holes when the first slabs have almost dried out (4–14 days).

Better for the plant

The first phase of restricted drainage means that the top layer of the slab will remain moist. This remaining water will neutralise the suction on the propagation block, which will consequently not dry out immediately. After a few days the roots will have penetrated the slab sufficiently and the irrigation may be switched off. Roots will grow above the dropping water level. It’s important not to irrigate the plants until the definitive drainage holes have been cut because that would cause the water level in the slab to rise above the tips of the roots.

“We have found that this approach leads to a better connection between the block and the slab and the development of a fine, well branched and healthier root system,” says Goes. “The slabs’ water content will also remain more uniform while they contain that layer of water, and this will result in a more uniform continuation of the control phase.”

Less water to be purified

As far as the substrate is concerned there’s no need to discharge the first drainage water. After all, it doesn’t contain any plant-unfriendly substances. However, many growers don’t like to recycle this water because young plants are extremely vulnerable in the darkest month of the year, also to any residues of crop protection products or disinfectants that may have been used for or after the previous crop. Growers who want to discharge the first drainage water instead of recycling it (at a later stage) must purify it first. Collecting, disinfecting and purifying such a first flush call for substantial storage and cleaning capacities. In this respect the stepped approach recommended by the technical specialist implies another advantage. Growers need initially process only 1/3 of the amount of drainage water, and their capacity will usually be satisfactory for this, especially in combination with the longer processing time. By the time that the second drainage hole is cut the plants will have consumed so much water that there will be very little water left to drain.

Cleaning the silos

“Another advantage of this approach is that growers have more time to clean their silos,” adds Goes. He ends his explanation with a final tip: “If you line the gutters with plastic sheet before you place your slabs in them there’ll be less risk of the accumulation of minerals, crop remains and algae. It will then take you less time to clean the gutters when you switch to a new crop. Such accumulations also involve a risk of diseases, so prevention is better than cure.”

Watch a video demonstrating this stepped approach above.

Grodan Newsletter

Do you want to learn more about Grodan? Feel free to sign up to our newsletter. Grodan ensures that growers can make optimum use of its products and services by interpretting the company’s knowledge of and experience with substrate cultivation in terms of up-to-date, crop-oriented advice. Ranging from tailor-made advice from crop consultants to newsletters, seminars and training courses and articles in trade journals.

Grodan, product

Other learning topics

Our latest blogs

20240910 RW-GR PHO 1541
By Mona Nazari
Sustainable Growing

Walking the greenhouses of Leamington, Ontario: a journey into the heart of Controlled Environment Agriculture

Grodan's 'Designed to grow together' philosophy blends nature, tech, and human leadership in horticulture, as Mona Nazari explores Canadian greenhouses.

20211201 RW-GR PHO 5618
By Grodan
Water Management
Sustainable Growing

Exploring the sustainable world of horticulture: Innovations and practices for commercial greenhouse growers

Horticulture offers sustainable agriculture through Controlled Environment Agriculture (CEA), growing diverse crops in high-tech greenhouses. Explore innovative technologies and practices in commercial greenhouse projects.

20240426 RW-GR PHO 1462
By Joyce Rasquin
Sustainable Growing

The horticulture sector holds just as much appeal for women as for men

Grodan's Marketing Director, Gonneke Gerkema, champions gender equality, joining GAIA to promote this. Joyce Rasquin, Manager Business Development, sees positive changes in Grodan.

WUR and Dutch Cotton - Cotton & Ginning-13
By Joyce Rasquin
Water Management
Sustainable Growing

The future of sustainable denim: G-STAR's homegrown denim initiative

Grodan and G-STAR unveil Homegrown Denim on May 29, 2024, a sustainable fashion milestone in collaboration with Wageningen University, Dutch Cotton, and Inno Growers.